Free DISA STIG and SRG Library | Vaulted

V-5645

Cisco Express Forwarding (CEF) must be enabled on all supported Cisco Layer 3 IP devices.

Finding ID
NET0949
Rule ID
SV-5645r4_rule
Severity
Cat II
CCE
(None)
Group Title
Cisco Express Forwarding (CEF) not enabled on supported devices.
CCI
(None)
Target Key
(None)
Documentable
No
Discussion

The Cisco Express Forwarding (CEF) switching mode replaces the traditional Cisco routing cache with a data structure that mirrors the entire system routing table. Because there is no need to build cache entries when traffic starts arriving for new destinations, CEF behaves more predictably when presented with large volumes of traffic addressed to many destinations such as a SYN flood attacks. Because many SYN flood attacks use randomized source addresses to which the hosts under attack will reply to, there can be a substantial amount of traffic for a large number of destinations that the router will have to handle. Consequently, routers configured for CEF will perform better under SYN floods directed at hosts inside the network than routers using the traditional cache.

Fix Text

1. If the Cisco Layer 3 IP device is not enabled by default, enable Distributed CEF Mode globally. Router(config)# ip cef distributed 2. If Distributed CEF Mode is not supported, enable Centralized CEF Mode globally. Router(config)# ip cef 3. If CEF is not supported in any capacity on the device, this finding is NA.

Check Content

Determine if the Cisco Layer 3 device supports the use of CEF switching mode. If the current IOS version available for the device does not support CEF in any capacity, this requirement will be NA. Most Cisco Layer 3 devices will support CEF in either Distributed or Central Mode. 1. If the device supports Distributed CEF Mode (dCEF), verify that it has been globally enabled. 2. If the device only supports Central CEF Mode (CEF), verify the function has been globally enabled. Many of the devices have CEF enabled by default and many of the configurations will not show if CEF functionality is enabled. To verify CEF is running on a Cisco Layer 3 device with IOS run the following command: router#show ip cef %CEF not running If CEF is shown to be not running, this is a finding.

Responsibility

Information Assurance Officer

IA Controls

ECSC-1