CISC-ND-000330
The Cisco switch must be configured to generate audit records containing the full-text recording of privileged commands.
Discussion
Reconstruction of harmful events or forensic analysis is not possible if audit records do not contain enough information. Organizations consider limiting the additional audit information to only that information explicitly needed for specific audit requirements. The additional information required is dependent on the type of information (i.e., sensitivity of the data and the environment within which it resides). At a minimum, the organization must audit full-text recording of privileged commands. The organization must maintain audit trails in sufficient detail to reconstruct events to determine the cause and impact of compromise.
Fix Text
Configure the Cisco switch to log all configuration changes as shown in the example below: SW4(config)#archive SW4(config-archive)#log config SW4(config-archive-log-cfg)#logging enable SW4(config-archive-log-cfg)#end
Check Content
Review the Cisco switch configuration to verify that it is compliant with this requirement. The configuration example below will log all configuration changes. archive log config logging enable Note: Configuration changes can be viewed using the show archive log config all command. If the Cisco switch is not configured to generate audit records of configuration changes, this is a finding.